2002 2003 2004 2005 2006 2007 Subaru Impreza WRX STI GD GG Momo Leather Steering Wheel & Airbag JDM OEM

Upgrade your driving interior with this premium Genuine JDM 2002-2007 Subaru Impreza WRX STI Momo Steering Wheel. Imported directly from Japan, this authentic OEM factory upgrade is sourced from clean Japanese-market GD sedan and GG wagon platforms. Manufactured by the legendary performance specialists at Momo exclusively for Subaru Tecnica International, this steering wheel features premium black perforated leather wrapped tightly around an ergonomically sculpted rim for maximum grip and tactile feedback. Complete with the iconic matching JDM center airbag module featuring a prominent red or silver logo, this genuine JDM component is the ultimate solution to replace a worn, peeling, or sun-damaged domestic wheel while preserving complete factory safety features.

---

Vehicle Specifications

• Year Range: 2002, 2003, 2004, 2005, 2006, 2007

• Make & Model: Subaru Impreza WRX & WRX STI (Second Generation / GD & GG Chassis)

• Brand: Momo (Genuine Subaru OEM Japanese Domestic Market Factory Issue)

• Material: Premium Perforated Outer Leather with Heavy-Duty Red/Black Stitching

• Diameter: Factory-spec 375mm sport steering profile

• Airbag Configuration: Single-stage or dual-stage deployable safety matrix (JDM spec)

• Origin: Japan (Genuine OEM Japanese Domestic Market Import)

• Condition: Premium Used Take-Off (Clean leather grain, tight structural stitching, no deep cuts, airbag intact)

---

Vehicle Fitments

• Direct Factory Replacement / Upgrade:

  • 2002-2007 Subaru Impreza WRX (Bugeye, Blobeye, Hawkeye Sedans & Wagons)

  • 2004-2007 Subaru Impreza WRX STI

  • 2003-2008 Subaru Forester XT (SG Chassis - Direct structural upgrade)

  • 2002-2004 Subaru Outback / Legacy (BE/BH Platforms sharing matching splines)

---

Included Parts

• Steering Wheel Core: Complete leather-wrapped genuine Momo wheel frame

• Airbag Module: Original JDM center horn pad and explosive deployment charge matrix assembly

• Cruise Control Switch: Attached factory steering column cruise control selector arm stalk (when applicable)

• Internal Harnessing: Factory horn contact wire and clock-spring plug connectors

---

Installation & USDM Airbag Safety Notes

• Battery Disconnection (Critical Safety Rule): Prior to beginning installation or unbolting your original steering column hardware, you must disconnect the vehicle's negative battery terminal and wait a minimum of 15 minutes to completely drain residual electricity and prevent accidental airbag deployment.

• Airbag Harness Modification Note: JDM Subaru models frequently utilize a single-stage airbag deployment connector wire, whereas later 2005-2007 USDM models utilize a dual-stage setup. Installers updating a dual-stage USDM vehicle may need to utilize standard automotive resistors or swap their domestic clock-spring wiring pigtails to match the JDM plug layout and ensure the SRS dashboard warning light does not illuminate.

• Spline Alignment: Ensure your front road wheels are tracked perfectly straight before sliding the Momo hub onto the steering shaft splines. Torque the center column mounting nut to factory Subaru specifications (typically 29 ft-lbs) using a calibrated torque wrench.